Annular seal Basic 1 made of stainless steel, V2A (material no.1.4301) Seal width 20 mm for non-pressing water up to 1.5 bar completely gastight and watertight built-in torque control EPDM rubber insert DIVIDING THE RING SEAL BASIC 1 To divide the press seal Basic 1, loosen and remove a screw. Unfold the front and rear press segment and cut the rubber press ring radially about 10 mm to the left or right of the screw hole with a sharp knife.
Annular seal Basic 1 made of stainless steel, V2A (material no.1.4301) Seal width 40 mm for pressing water up to 2.5 bar completley gastight and watertight built-in torque control EPDM rubber insert DIVIDING THE RING SEAL BASIC 1 To split the annular seal Basic 1, loosen and remove a screw. Unfold the front and rear press segment and cut the rubber press ring radially about 10 mm to the left or right of the screw hole with a sharp knife.