Wave anchors Wave anchor to anchore single-sided system to the floor, to mount formwork element, A-frames, scaffolding bracket, etc.
Seal "onion ring" technology Ø 150 mm - fixed... Super segment ring technology for cables and pipes 3 segment rings with diameter lettering for Ø 75, 90 and 110 mm Subsequently divisible for pipes that have already been laid for core drilling / wall sleeves Ø 150 mm Seal width 40 mm,...
Annular Seal - cable Ø 100 mm foldable Annular seal - 4-fold cable Ø 100 mm MR Ø 6-40 mm Tested up to 10 m WS (1 bar) Hinged Annular seal for core drilling / wall sleeves Ø 100 mm Segment ring technology for 1 cable / tube Ø 25, 32 or 40 mm as well as 3 cables Ø 6-18 mm...
Cartridge gun for 310ml / cartridge Cartridge gun used for cone glueing. Attention: Without Contact adhesive cartridge! The glue is a seperate article: Contact adhesive X1 cartridge / 290 mL
Setting tool for knock-in dowel DW15 The knock-in dowels are pre-expanded with this setting tool. Then the anchor rod can be screwed in. Setting tool for knock-in dowel DW15
Cartridge gun for Flex 2000 The Flex 2000 cartridge is clamped in the cartridge gun and pressed into the penetration from back to back with an attached flexible spray nozzle in a layer thickness of at least 8 cm.
Rebar spacer ZZ - PVC free ZZ ISO rebar spacer is a skidproofed and tilt secured spacer for the bottom reinforcement. The material is PVC free. There will be no shrinking as the concrete encloses the batten completly. Suitable for XPS, isolation or other soft...
Plastic fixation clip type B Plastic fixation clip type A to impress into fresh concrete or in boreholes Ø 8 mm, Mountig al 15 cm
PE wall damp course The damp proof courses protect the masonry from rising moisture. Both sides of the material are ripped and increase the liability to the mortar. Material: Polyethylen, slip-resistant; Thickness: ca. 0,4 mm.
Mauerkragen aus TPE - Themoplastischem Elastomer MPA certificated! Masonry collars from TPE-Themoplastic Elastomer Application area: The sealing collar is used whenever a water-tight lead-through of pipe lines through foundation slabs, walls, and masonry is required. The sealing...
Ringraumdichtung Basic 1 - Dichtungsbreite 40 mm Annular seal Basic 1 made of stainless steel, V2A (material no.1.4301) Seal width 40 mm for pressing water up to 2.5 bar completley gastight and watertight built-in torque control EPDM rubber insert DIVIDING THE RING SEAL BASIC 1 To...
Blind plug compact V2A Ø 50 - 250 mm Gas and water tight sealing for drill holes, tubes, etc. Rubber insert made of EPDM, press plates made of stainless steel V2A completly gastight and watertight pressing water 2.5 bar (30 m WS) radon tight KTW/W270 drinking water - quality
Viewed