Construction trailer 3.50 m, furnished
Product number:
36D35
Skip product gallery
Customers also viewed
Raumcontainer CAMP
Equipment:
Standard exterior paint frame and walls are gray/whiteAußenlackierung Rahmen und Wände grau/weiß
Standard PVC-floor covering
Exterior door: 1000 x 2226 mm (External dimension)
Tilt and turn windows: 1000 x 1250 mm insulation glazing with PVC-shutter
Ventilation grills
Walls and roof isolated
Internal heigth 2260 mm (other heigths on request, as.Example. 2300 mm)
With 4 crane hooks
Electrical installation: 380 / 200 Volt
1 Protection cap
Input and Output 380 V / 16 Ampere
2 Circuit breaker (by length 5 6 Meter 3 Stück)
1 Light switcher
1 socket Schuko 10 / 16 Ampere (by length 5 and 6 metres 2 pieces)
Rebar spacer CLOSED
Spacing strip to use on soft underground.
Mill length: 200 cm.
Other lenghts available. (PVC - free by request)
Log in to see more information
Rebar spacer CLOSED
Spacing strip to use on soft underground.
Mill length: 200 cm.
Other lenghts available. (PVC - free by request)
Log in to see more information
SAM-Plastic taper locks
Plastic Taper locks
after removing the spacer the wedge closes the exposed concrete element. The result is an attractive exposed concrete surface.
Log in to see more information
Concrete screw - Multi-Monti
Verzinkte patentierte Betonschraube mit Sechskant und Flansch ETA-15/0784 und 15/0785 Zulassung- Zwei Einschraubtiefen — Ein echtes Plus für mehr Flexibilität und Wirtschaftlichkeit (alle Hinweise dazu auf der Verpackung)
Neuer Schraubenkopf:
Sechskantkopf mit angepresster Scheibe
Kopfprägung MMS+
Erhöhung des Gewindeaußendurchmessers:
Größere hinterschnittene Fläche durch das Gewinde im Beton
Optimierte Tragfähigkeit im Beton
Überarbeitete Funktionsspitze:
Stärkere Verzahnung und größerer Außendurchmesser der Spitze
Größerer Hinterschnitt
Geringeres Verschleißverhalten der Funktionsspitze
Weniger Verschleiß beim Einschrauben
Hoher Montagekomfort – geringe Montagedrehmomente
Für Befestigungen in Beton nach ETA-15/0784 und ETA-15/0785
Log in to see more information
Pressure cone standard (PVC-free)
The pressure cones are attached to the spacer tube.
After concreting, the pressure cones are removed from the concrete and can be reused.
Log in to see more information
Rebar spacers with sidewise recesses
U-shaped bar spacer made of plastic used for the efficient rearrangement of the reinforcement.
Mill length 200 cm.
Other lengths on request.
Log in to see more information
VIBADISTANZ spacer tube (VDZ) incl. 2 plugs
Formwork spacer tube "made of one piece" with two sealing plugs. Secure the wall thickness reliably!
Material: HDPE
Log in to see more information
Abstandhalter für Schienenschalung mit Nocken
Abstandhalter für Schienen System mit Noppen.
Mit aufgesteckten Kunststoffelementen für Sichtbeton Oberflächen.
Log in to see more information
Mauerkragen aus TPE - Themoplastischem Elastomer
MPA certificated!
Masonry collars from TPE-Themoplastic Elastomer
Application area:The sealing collar is used whenever a water-tight lead-through of pipe lines through foundation slabs, walls, and masonry is required.
The sealing collar, which has passed the pressure test at 5 bar, prevents moisture from getting into the building along the outer pipe walls.
Tested for impermeability up to 50 m water column.
Properties:The sealing collar is supplied in pre-assembled condition with 2 stainless steel straps.
The circular, 4 cm wide collar, which is equipped with additional waterstops, prevents liquids from getting into the building.
Small waterstops inside the collar ensure water-tightness up to a water column of 50 m after tightening of the stainless steel fastening straps.Assembly
clean pipe surface if necessary
slide on the sealing collar and fix it in the centre of the concrete/wall
tighten the fastening straps
Log in to see more information