Ringraumdichtungen

for every annular seal with a sealing width of 40 mm

The P-Cable Basic HRD annular seal is available in various designs. The following product identification is used: SG x (number of holes) / y-z (area in which the hole can be adjusted)

Gas and water tight sealing for drill holes, tubes, etc. Rubber insert made of EPDM, press plates made of stainless steel V2A completly gastight and watertight pressing water 2.5 bar (30 m WS) radon tight KTW/W270 drinking water - quality

Super segment ring technology for cables and pipes; 12 segment rings with a diameter of 16 - 65 mm; simply tear off the segments until they fit split design, suitable for subsequent installation Seal width 40 mm, pressure-tight up to 1...

Super segment ring technology for cables and pipes Open the pipe seal. Cut into the selected segment rings at the predetermined separation point with a sharp knife and tear off 5 segment rings with a diameter of 25 - 63 mm segment ring...

The P-Cable Basic HRD annular seal is available in various designs. The following product identification is used: SG x (number of holes) / y-z (area in which the hole can be adjusted)

The P-Cable Basic HRD annular seal is available in various designs. The following product identification is used: SG x (number of holes) / y-z (area in mm which the hole can be adjusted)

The P-Cable Basic HRD annular seal is available in various designs. The following product identification is used: SG x (number of holes) / y-z (area in which the hole can be adjusted)

The P-Cable Basic HRD annular seal is available in various designs. The following product identification is used: SG x (number of holes) / y-z (area in which the hole can be adjusted)

Annular seal Basic 1 made of stainless steel, V2A (material no.1.4301) Seal width 20 mm for non-pressing water up to 1.5 bar completely gastight and watertight built-in torque control EPDM rubber insert DIVIDING THE RING SEAL BASIC 1 To...

Annular seal Basic 1 made of stainless steel, V2A (material no.1.4301) Seal width 40 mm for pressing water up to 2.5 bar completley gastight and watertight built-in torque control EPDM rubber insert DIVIDING THE RING SEAL BASIC 1 To...

Annular seal Basic 1 made of stainless steel Stainless V2A Seal width 40 mm completely gastight and watertight built-in torque control EPDM rubber insert To split the press seal Basic 1, loosen and remove a screw. Unfold the front and...