Meter mark badge RS with brush

Annular seal Basic 1 made of stainless steelStainless V2A Seal width 40 mm completely gastight and watertight built-in torque control EPDM rubber insert To split the press seal Basic 1, loosen and remove a screw. Unfold the front and rear press segment and cut the rubber press ring approx. 10 mm to the left or right of the screw hole with a sharp knife.

Annular seal Basic 1 made of stainless steel, V2A (material no.1.4301) Seal width 40 mm for pressing water up to 2.5 bar completley gastight and watertight built-in torque control EPDM rubber insert DIVIDING THE RING SEAL BASIC 1 To split the annular seal Basic 1, loosen and remove a screw. Unfold the front and rear press segment and cut the rubber press ring radially about 10 mm to the left or right of the screw hole with a sharp knife.

Mounting plates 70 x 70 mm without slot Mounting plates with slot on request

Mounting plates 70 x 70 mm without slot Mounting plates with slot on request

Mounting plates 70 x 70 mm without slot Mounting plates with slot on request

Annular seal Basic 1 made of stainless steel, V2A (material no.1.4301) Seal width 40 mm for pressing water up to 2.5 bar completley gastight and watertight built-in torque control EPDM rubber insert DIVIDING THE RING SEAL BASIC 1 To split the annular seal Basic 1, loosen and remove a screw. Unfold the front and rear press segment and cut the rubber press ring radially about 10 mm to the left or right of the screw hole with a sharp knife.

Mounting plates 70 x 70 mm without slot Mounting plates with slot on request

Annular seal Basic 1 made of stainless steel, V2A (material no.1.4301) Seal width 20 mm for non-pressing water up to 1.5 bar completely gastight and watertight built-in torque control EPDM rubber insert DIVIDING THE RING SEAL BASIC 1 To divide the press seal Basic 1, loosen and remove a screw. Unfold the front and rear press segment and cut the rubber press ring radially about 10 mm to the left or right of the screw hole with a sharp knife.

Mounting plates 70 x 70 mm without slot Mounting plates with slot on request

VIBA - Saubär is an environmentally friendly release agent emulsion based on renewable raw materials. It has been specially developed for producing high-quality exposed concrete surfaces in both precast and cast-in-place concrete construction. The special formulation ensures very bright, high-quality concrete surfaces. Application VIBA - Saubär is applied evenly, thinly and sparingly using a standard commercially available spray device. Puddles and accumulations of material should be avoided, as these can lead to a reduction in the quality of the concrete surface, particularly in recesses and along edges. After application, the emulsion forms a milky-white film, which disappears once the water component has evaporated. Concreting can then begin. The evaporation time depends on weather conditions (approx. 10–30 minutes at 20 °C and 60% relative humidity). Properties Based on renewable raw materials Excellent release properties Suitable for visually high-quality and bright concrete surfaces Environmentally friendly: FREE FROM solvents and mineral oils Low odour Ready to use Easy to spray

The pressure cones are attached to the spacer tube. After concreting, the pressure cones are removed from the concrete and can be reused.

The RS20 and RS21 badges are mounted on an unplastered wall and are unmistakable documents for all craftsmen.