Properties
| Medium pipe Ø: | 110 - 160 mm |
|---|---|
| ø in mm: | 200 mm |
Seal "onion ring" technology Ø 200 mm - divisible MR Ø 110, 125, 135, 160 mm
Available, delivery time: 1-3 days
Price on request
Properties
| Medium pipe Ø: | 110 - 160 mm |
|---|---|
| ø in mm: | 200 mm |
Customers also viewed
WELLO, the lining tube made of PE with an all-round swelling coating. The tube is smooth inside. The undulating outside clings to the concrete. Two swelling tapes applied around the center also prevent water from entering the structure Wello casing, double security through corrugation and swelling tape, sealing by means of an annular seal. Tested up to 30m water column.
By draining waste water in a uniform flow direction without unnecessary edges, clogged pipes and nasty surprises are avoided. This can be done easily with the VIBA KG pipe bushing type UDM. Thanks to the innovative connection, external KG pipes can be connected to the spigot with the socket without the flow direction of the waste water being influenced by additional edges. Clogged pipes: no chance! Filling flange (flange made of ABS). When using plastic-modified bitumen coatings (load case according to DIN 18195 Part 4), the outer seal can be applied using the filler flange.
All versions with failure protection, accident proof. Universally usable as pressure- and traction props to support and adjust prefabricated concrete elements and formwoks. Flexible head- and baseplate Headplate: 140 x 100 x 6 mm, with hole ø 20 mm G-hook: Ø 14 mm (no loosing)
Gas and water tight sealing for drill holes, tubes, etc. Rubber insert made of EPDM, press plates made of stainless steel V2A completly gastight and watertight pressing water 2.5 bar (30 m WS) radon tight KTW/W270 drinking water - quality
Annular seal Basic 1 made of stainless steelStainless V2A Seal width 40 mm completely gastight and watertight built-in torque control EPDM rubber insert To split the press seal Basic 1, loosen and remove a screw. Unfold the front and rear press segment and cut the rubber press ring approx. 10 mm to the left or right of the screw hole with a sharp knife.
Annular seal Basic 1 made of stainless steel, V2A (material no.1.4301) Seal width 40 mm for pressing water up to 2.5 bar completley gastight and watertight built-in torque control EPDM rubber insert DIVIDING THE RING SEAL BASIC 1 To split the annular seal Basic 1, loosen and remove a screw. Unfold the front and rear press segment and cut the rubber press ring radially about 10 mm to the left or right of the screw hole with a sharp knife.
WELLO, the lining tube made of PE with an all-round swelling coating. The tube is smooth inside. The undulating outside clings to the concrete. Two swelling tapes applied around the center also prevent water from entering the structure Wello casing, double security through corrugation and swelling tape, sealing by means of an annular seal. Tested up to 30m water column.
The P-Cable Basic HRD annular seal is available in various designs.The following product identification is used: SG x (number of holes) / y-z (area in which the hole can be adjusted)
• Can be set up individually or in a group at any angle. • Since no concrete feet are required, the barrier can be used without any problems. • Particularly suitable for short-term barriers in civil engineering. • Ideal for events etc.