Properties
| Medium pipe Ø: | 63/76/90/110 mm |
|---|---|
| ø in mm: | 150 mm |
Seal "onion ring" technology Ø 150 mm - fixed type 1 MR Ø 32, 40, 50, 63, 76, 90, 110 mm
Available, delivery time: 1-3 days
Price on request
Properties
| Medium pipe Ø: | 63/76/90/110 mm |
|---|---|
| ø in mm: | 150 mm |
Customers also viewed
Sealing cap + formwork aid for WELLO and FASO lining tube reusable
Annular seal Basic 1 made of stainless steel, V2A (material no.1.4301) Seal width 40 mm for pressing water up to 2.5 bar completley gastight and watertight built-in torque control EPDM rubber insert DIVIDING THE RING SEAL BASIC 1 To split the annular seal Basic 1, loosen and remove a screw. Unfold the front and rear press segment and cut the rubber press ring radially about 10 mm to the left or right of the screw hole with a sharp knife.
WELLO, the lining tube made of PE with an all-round swelling coating. The tube is smooth inside. The undulating outside clings to the concrete. Two swelling tapes applied around the center also prevent water from entering the structure Wello casing, double security through corrugation and swelling tape, sealing by means of an annular seal. Tested up to 30m water column.
Sealing cap + formwork aid for WELLO and FASO lining tube reusable
Annular seal Basic 1 made of stainless steel, V2A (material no.1.4301) Seal width 20 mm for non-pressing water up to 1.5 bar completely gastight and watertight built-in torque control EPDM rubber insert DIVIDING THE RING SEAL BASIC 1 To divide the press seal Basic 1, loosen and remove a screw. Unfold the front and rear press segment and cut the rubber press ring radially about 10 mm to the left or right of the screw hole with a sharp knife.