Properties

Tragkraft:	160 kN
ø in mm:	36 mm

Kupplungsmutter Ø 15,0 mm rund

Product number: 65CI15R

Available on request

Price on request

Stk

Properties

Tragkraft:	160 kN
ø in mm:	36 mm

Customers also viewed

Coupling nut Ø 15,0 mm

Coupling nut for Ø 15 - Ø 26,5 mm

Hexagon nut

Galvanized cast or weldable for anchor rods Ø 12.5 / 15/20 and 26.5 mm.

Hexagon nut

Galvanized cast or weldable for anchor rods Ø 12.5 / 15/20 and 26.5 mm.

Formwork stop GFK conrete grey

Formwork stop made of fibreglass. Pins Ø: 10 mm; Length: 100 mm ADVANTAGES: Non-corrosive High strength and stable Chemical resistance Fast and easy installation INSTALLATION: Mark the position of the formwork with a snap line. Drill periodically holes with a diameter of 10mm along the marking. ATTENTION: Please consider the length of the pins.

Sylomer-Polyurethanlager SR11

Sylomer impact sound bearing type SR 11 - YELLOW Area of application Pressure load Deformation Form factor dependent, the specified values apply to form factor q = 3 Static area of application(static loads) up to 0,011 N/mm² approx. 7% Dynamic area of application(static and dynamic loads) up to 0,016 N/mm² approx. 20% Peak loads(rare, short-term loads) up to 0,5 N/mm² approx. 80%

Tie rod extractor Ø 15/20 galv.

Version: galvanized.Suitable for anchor rods Ø 15 and 20 mm.

Sylomer-Polyurethanlager SR110

Sylomer sound bearing bearing type SR110 Area of application Pressure load Deformation Form factor dependent, the specified values apply to form factor q = 3 Static area of application(static loads) up to 0,110 N/mm² approx. 10 % Dynamic area of application(static and dynamic loads) up to 0,160 N/mm² approx. 20% Peak loads(rare, short-term loads) up to 3,0 N/mm² approx. 70%

Binding wire / tension wire - roll

Type annealed

Loop Anchor

To anchore single-sided system to the floor, to mount formwork element, A-frames, scaffolding bracket, etc. Design: Black

Formwork oil Prägnit ST300

Tested formwork oil suitable for all formworks. Good degradable with certificate Mixture of mineral oil and plant-based oil Apply a thin layer for best effect with protection of the formwork. No cleaning of the formwork neccessary. Degredable for 81% within 21 days.