Connection clamp, galvanized

Product number: 38AA07

Stk

Description

Connection clamp for fence element
Safety connection clamp
Galvanized

Zubehör

Mobilzaun Element 350 x 200 cm

Mobile fences are robust, versatile fence-system for short run and effective hedge for building sites and events. The elements with circumferential frame can be connected with the hooks - loops system. The length of the Standard elements = 342 cm.

Details

Customers also viewed

Safety connection clamp, galvanized

Safety mounting kit (clamp) for mobile fence

Recycling-Foot for mobile fence

Gray 4 holes Ø 45 mm Model plastic PE

Key for security mounting set (clamp)

Key for security mounting set (clamp) Art. No. 38AA071

Mauerkragen aus TPE - Themoplastischem Elastomer

MPA certificated! Masonry collars from TPE-Themoplastic Elastomer Application area:The sealing collar is used whenever a water-tight lead-through of pipe lines through foundation slabs, walls, and masonry is required. The sealing collar, which has passed the pressure test at 5 bar, prevents moisture from getting into the building along the outer pipe walls. Tested for impermeability up to 50 m water column. Properties:The sealing collar is supplied in pre-assembled condition with 2 stainless steel straps. The circular, 4 cm wide collar, which is equipped with additional waterstops, prevents liquids from getting into the building. Small waterstops inside the collar ensure water-tightness up to a water column of 50 m after tightening of the stainless steel fastening straps.Assembly clean pipe surface if necessary slide on the sealing collar and fix it in the centre of the concrete/wall tighten the fastening straps

Three-layer plate Standard, thick: 27 mm

Three layer plywood weather-resistant glued Surface with melamine-resin (yellow). Other colours on request. Special formats on request Additional millings possible! All standard cuts are possible!

Gate-element for fence 200 cm

Gate-element for fence Design galvanized 120 x 200 cm

Ringraumdichtung Basic 1 - Dichtungsbreite 40 mm

Annular seal Basic 1 made of stainless steel, V2A (material no.1.4301) Seal width 40 mm for pressing water up to 2.5 bar completley gastight and watertight built-in torque control EPDM rubber insert DIVIDING THE RING SEAL BASIC 1 To split the annular seal Basic 1, loosen and remove a screw. Unfold the front and rear press segment and cut the rubber press ring radially about 10 mm to the left or right of the screw hole with a sharp knife.

Kantenreiniger für Schalungsplatten

Handgerät für die einfache Reinigung von Kanten von Schaltafel von 12 - 27 mm.

Strukturmatten / Matrizen für Betonwand

Textured formliners from Schalbau Vitzthum in various designs for your exposed concrete wall. The mats can be attached to the formwork either with glue or nails. Processing instructions in the download tab. Tolerance range length and width +/- 2.0 mm

Supporting strut gvz. length 195 cm

Stütze für Bauzaun / Mobilzaun zur Sicherung vor Umkippen. Fußplatte 14 x 23 cm für Spieß Ø 12 - Winkel 50x50 mm Erdnägel und Schelle nicht inkludiert!